Bandsaw Base

The purpose of this project is to make moving my Ryobi bandsaw (with included stand) easier because dragging it around on the garage floor is annoying to my ears. For some reason, it's always in my way too. So we start off with some square tubing I found in a dumpster behind an office supply store, and mitered the ends so I can form a simple rectangle matching the base.

Originally I was going to bolt on the casters but since I had the welder handy and I was too lazy to find bolts of appropriate diameter and length, a few zaps and they're stuck for good.

And we're done. Now when it's in my way, I can just push it over lol.